top of page

HIPP UK

WHAT YOU NEED

  • Boiled Water

  • Sterilized Bottles

  • Teat & Cap

  • Formula Powder

  • Measuring Spoon (found in your formula box)

STEPS

  1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions. 

  2. Do not use artificially softened or repeatedly boiled water. Boil 1 litre of freshly run water & leave  to cool for no longer than 30 minutes. 

  3. Measure the required amount of water into a sterilized bottle (referring to the feeding guide below).

  4. Level off the powder using the scoop leveller (do not press the powder).fluid ounce of water, approximately 30 millilitres). Using the scoop provided, add the correct number of scoops of powder (1 level scoop of power to each

  5. Place sterilized teat & cap on the bottle & shake well until all the powder has dissolved (approximately 15 seconds).

  6. Cool to drinking temperature (approximately 37 Degrees Celsius) by holding the bottle under cold running water, & feed immediately. Always test the temperature of the milk before feeding.

FEEDING GUIDE STAGE 1

IMG_0084.PNG

FEEDING GUIDE STAGE 2

IMG_0085.PNG

FEEDING GUIDE STAGE 3

IMG_0086.PNG

HIPP UK RTF

WHAT YOU NEED

  • A bottle of HiPP Ready to Feed Stage 1

  • Sterilized Bottle

  • Teat & Cap

STEPS

  1. Wash hands & sterilize all equipment following the bottle's manufacturer's instructions.

  2. Check expiration date.

  3. Remove the plastic lid and gently squeeze the bottle to make sure the foil is intact.

  4. Shake bottle well.

  5. Pour required amount of milk into the sterilized feeding bottle.

  6. HiPP UK Ready to Feed Stage 1 can be given at room temperature or warmed if desired. For hygiene reasons, discard unfinished milk in feeding bottle as soon as possible and always consume within 2 hours.

FEEDING GUIDE

IMG_0518.jpg
bottom of page